🎄5V RGB Pixel Power Injection & Prop Build (2019) 🎄

I built a large 4’x16′ pixel matrix using Chroma Mesh from Boscoyo and 1,024 5V pixels. I show how to model this in xLights to get the wiring plan and I built is as a single string of lights using one controller connection. This requires a lot of power injection. but it’s pretty easy to do on a matrix.

2 thoughts on “🎄5V RGB Pixel Power Injection & Prop Build (2019) 🎄

  1. Stephen Gill

    hi love the vid, just done 150 bullet pixels sore thumb and fingers…how do you inject power using another unit.
    Building mega tree so would like to lessen the load by placing power units every 90 deg and wire up that 90 deg area x 4. the strings I am using have a pig tail for power on every 50 nodes neg and pos would this work to take back the wires to the power supply. Getting confused as on line people say tie in the neg on the supply, is this the neg from mains or neg from low side (5volts), any help gratefully received its my first BIG display piece. Just love the videos, tried to get to the expo but just too far plus I would buy stuff and have no luggage allowance left!!!

  2. Dog Father Post author

    Thanks! First, I run my pixels at 30% which reduces the power draw. For example, I run my 1200-pixel megatree off one 350-watt power supply. 5V strings generally need power every 50-80 nodes. 12V strings generally need power every 80-100 nodes. That’s for 100% brightness. Let the pixels tell you if they need more power. When building the prop, leave the ends at a point you could add power easily if needed. IOW, don’t solder and heat shrink everything until you’ve connected everything up and tried it. If feeding a single string with 2 power supplies, I always teach breaking the positive somewhere so you don’t burn out the power supplies. I have had people tell me that pixels between two power supplies provides enough load so the power supplies won’t fight each other, but I have no specifics so I say just break the positive somewhere in the middle of the string. Never connect the positives of two power supplies without a load between them. Always connect the negatives (low sides) of the two supplies, otherwise the lights will probably flicker uncontrollably due to floating voltages.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.